Software Overview; Mts Flextest (Series 793) Controller Software - Station Manager Application - MTS Systems Landmark 370 Series Operation

Item Control Description
5 Hydraulic Optional control that raises and lowers the crosshead. The crosshead must not
crosshead be moved while it is locked. Load frames without hydraulic positioning require
positioning the operator to use a hoist to support and move the crosshead.
control
6 Emergency Removes the hydraulic power and stops the test program. Press this button to
Stop (E- remove hydraulic power, and twist the switch clockwise to release it. Use the
Stop) Emergency Stop button to shut down your test if something unexpected
should happen.
7 Actuator Controls actuator velocity. There are two positions:
velocity
limiting
switch

Software Overview

Running a test on an MTS Landmark load frame system typically requires the use of the following two
MTS software programs:
MTS FlexTest (Series 793) Controller Software
Operators primarily use MTS FlexTest controller software to set up the station for testing. While there
are a number of applications that are part of MTS FlexTest software, this manual focuses on using the
Station Manager application to set limits, display sensor data, and move the actuator for specimen
installation.
MTS Multipurpose (MP) Express Application
The MTS Multipurpose Express application is a light version of the MTS Multipurpose Elite application
and is designed specifically for test operators. Operators primarily use MTS TestSuite MP Express to
run tests and generate reports.
MTS FlexTest (Series 793) Controller Software - Station Manager
Application
Purpose
The Station Manager application is primarily used to set up your station for a test. The major tasks
necessary to prepare the station for the Example HCF Test include:
Opening a Station
l
Using the Main Window to Open Other Windows
l
Setting Limits
l
Landmark™ Test System Operation
Series 370 Load Unit Controls (continued)
One for reduced fluid flow to the actuator resulting in slow speed of the
l
actuator rod for specimen installation.
One for full fluid flow resulting in normal, high-speed testing operation.
l
System Introduction
31