MTS Systems Landmark 370 Series Operation page 117

Recommended service to be performed at each running time interval noted (continued)
Calendar Time using 8 hour
Running Time rate per day
Running Time-Hours
Crosshead Unlock Causes Program
Interlock
Load frame Support Airbags/Pads
Crosshead Movement is Smooth
Hydraulic Crosshead Locks are
Functioning Properly
Bleed Crosshead Lift Cylinders
Lubricate Manual Crosshead Lock
Bolts
Replace Hydraulic Lock Cap
1
Screws
Actuator
Cursory Check of Actuator
Actuator Area is Dry
Actuator Platen Area is Clean
Piston Rod Wear is Acceptable
Bionix Lubricate Axial/Torsional
Spline (75-100 hrs)
Verify Performance, Low Velocity,
Up Direction
Verify Performance, Low Velocity,
Down Direction
Hydraulic Service Manifold
Cursory Check of Hydraulic Service
Manifold
Monitor Filter Indicators
1
Replacement of the hydraulic crosshead lock cap screws is recommended every 5 years or 5500 duty
cycles, whichever comes first.
Landmark™ Test System Operation
Daily Weekly Biweekly
8 40 80
MTS
MTS
MTS
Maintenance
Annually
500 1000 1,500 2,000
MTS MTS MTS MTS
MTS MTS MTS MTS
MTS MTS MTS MTS
MTS MTS
MTS MTS
MTS
MTS
MTS MTS MTS MTS
MTS MTS MTS MTS
MTS MTS MTS MTS
MTS MTS MTS MTS
MTS MTS MTS MTS
MTS MTS MTS MTS
MTS MTS MTS MTS
MTS MTS MTS MTS
MTS MTS MTS MTS
117