Speed Setup; Introduction; Speed Range - Safeline Signature Operating And Instruction Manual

Introduction

This menu is used to set-up the speed range and
product speed for the detector
The performance of metal detectors may be improved
if a detector is able to focus in on a specific speed
range, rather than have to cope with unknown speed
ranges.
In the speed menu it is possible to set the detector
into one of three ranges and then further define the
product speed automatically in terms of metres/minute
(feet/minute in U.S. versions)

Speed range

This display is used to select between one of three
possible speed modes.
This mode allows for precise
NORMAL
calibration of the speed of the product to provide
additional filtering inside the detector which in most
cases will allow greater sensitivities to be used.
This mode allows for faster speeds
FAST
than the NORMAL mode to be achieved. The
additional performance increase of the NORMAL
mode is NOT available in this mode.
VARIABLE
products with varying speeds to be used. The
additional performance increase of the NORMAL
mode is NOT available in this mode.
In most cases selecting NORMAL speed range will
allow better sensitivities to be attained than the other
two speed ranges
Press the soft key adjacent to
VARIABLE/NORMAL/FAST message to successively
select the different speed ranges. When the speed
range required is showing on the display press ETC to
move to the next display.
62

SPEED SETUP

This mode allows for
OPERATING INSTRUCTIONS
Notes
(1) Any settings altered in this menu will affect
ALL of the product numbers.
(2) The features Product Signal Cancellation and
Automatic tracking are not available in the
VARIABLE speed range.
NOTE
Remember to record all settings on the Settings
Sheets at the rear of the manual.
4618 - 021