Safeline Signature Operating And Instruction Manual page 112

b) For loose products
i) Place the metal contaminant on the centre
of the conveyor belt.
ii) Pass the product with the metal contaminant
attached through the detector aperture.
iii) Use the cursor Up and Down keys to adjust
the Signal Shift so that the reject device
operates just as the metal contaminant
reaches it.
7) Press the soft key adjacent to REJECT SHIFT.
a) For packaged or separate products
i) Place the metal contaminant at the front
/leading edge of the product.
ii) Pass the product with the metal contaminant
through the detector aperture, ensuring that
the product does not slip or skew.
iii) Use the cursor Up and Down keys to adjust
the Reject Shift so that the metal
contaminant is rejected consistently and
accurately.
b) For loose products
i) Place the metal contaminant on the centre
of the conveyor belt.
ii) Pass the product with the metal contaminant
through the detector aperture.
iii) Use the cursor Up and Down keys to adjust
the Reject Shift so that the metal
contaminated product contaminant is
rejected with the minimum of wasted
product.
8) Press the Enter key when the required value
has been set.
9) Press the Enter key a second time to proceed
to the next display.
.
96
OPERATING INSTRUCTIONS
4618-021