Safeline Signature Operating And Instruction Manual page 42

Speed change guide
Introduction
This guide details in a step-by-step manner all settings that may have to be changed if the speed of
operation of the detector is changed.
NOTE
All of the following items may be set from the
Engineer Mode of operation
1) 'Product speed' on page 45.
2) 'Vibration Setup' on page 44
3) 'Reject Timers' and subsequent timer
sections on pages 42 and 78.
4) 'Reject Confirmation' on page 46.
5) 'Product Number Settings Guide' on
page 23.
Step 1)
Enter the Engineer security code.
Step 2)
Select the Speed Setup Menu.
Step 3)
Select the 'Auto Adjust' feature and follow the
instructions on the display.
Step 4)
On completion of step 3) the Product Speed
display will show the current speed of the
product.
Step 5)
Press the PROG/EXIT key.
26
How to... 'Measure the speed of the product'
OPERATING INSTRUCTIONS
Set up the speed of the product - either manually or
automatically.
Set up the detector to the vibration characteristics of
your system.
Set up the required timer groups to the appropriate
timer type and settings. Note this step is NOT
required for timers which are synchronised to the
product speed (e.g. tm3 and tm3G timer types).
If you are using the reject checking facilities of the
detector.
See the earlier guide.
'Entering security codes' on page 19.
'Speed Setup Menu' on page 45
'Product Speed' on page 63.
'Product Speed' on page 63.
4618 - 021