Security Setup; Introduction - Safeline Signature Operating And Instruction Manual

Introduction

At Safeline metal detectors are shipped from the
factory with the following security codes pre-
programmed.
Code 0001 =
Code 0002 =
Code 0003 =
Code 0004 =
Code 0005 =
Operator access
This display enables the detector to operate such that
by entering the OPERATOR security code it is
possible to change the sensitivity and phase of a
product as well as just changing the product number.
LIMITED Press the soft key next to LIMITED to
prevent any person with an OPERATOR security
code from being able to alter phase and sensitivity.
FULL Press the soft key next to FULL to allow any
person with an OPERATOR security code to adjust
phase and sensitivity.
4618-021

SECURITY SETUP

Operator mode
Supervisor mode
Engineer mode
QA Inspector mode
Viewing mode
OPERATING INSTRUCTIONS
The Security Setup sub-routine allows the changing of
the security codes for up to four of the operating
modes (i.e. Supervisor, Engineer, QA Inspector and
Viewing). The Security Setup sub-routine can only be
accessed from the Engineer Mode.
!
CAUTION
Take care to memorise your new security codes.
59