Safeline Signature Operating And Instruction Manual page 40

Performance Validation Guide
Introduction
This guide will lead you through setting up the performance validation features of the detector.
NOTE
The 'Universal Settings Guide' should be used
before this guide.
NOTE
All of the following items may be set from the QA
Inspector Mode of operation.
1) 'Test Samples' on page 69.
2) 'Test interval' on page 71.
3) 'Overdue Period' on page 71.
4) 'Change QA Operator Code' on page 72.
Step 1)
Enter one of the QA Operators security codes.
Step 2)
Select the material of the test sample.
Step 3)
Pass the test sample with the product through
the detector aperture.
Step 4)
Go back to Step 2) if testing more samples,
else press the PROG/EXIT key.
24
How to... 'Carry out a Performance Validation Test'
OPERATING INSTRUCTIONS
NOTE
The 'Product Number Settings Guide' should be
used before this guide.
Set up the test ball sizes that the operator will be
prompted to pass through the aperture when
performing validation tests.
Set up the test interval so the detector will prompt the
operator to perform Performance Validation Tests at
regular intervals.
Set up the amount of time to allow after prompting for
a test before the test is considered overdue.
Set up the security codes (maximum of 9 separate
codes) for the operators who will be performing the
Performance Validation Tests.
'Entering security codes' on page 19.
'Select Test Material' on page 74.
'Select Test result' on page 75.
4618 - 021