Select And Update Timer; Inverse Detection - Safeline Signature Operating And Instruction Manual

Select and Update Timer

!
CAUTION
Ensure you have read the sections on timers in
the Features section of the manual (see page 3).
This display is used to either:
1) Select which timer group the current product
number should use.
or
2) Select which timer group the current product
number should use AND adjust the timer
group settings such as timer type, delay time
etc. The currently selected timer group will
be indicated by a flashing cursor appearing
over the group letter. Press the soft key
adjacent to the group letter required. As
soon as one of the three soft keys for the
different groups is pressed the display
opposite will appear.
If you are only intending to select the group to which
the current product number will apply (number 1.
above) then press the soft key adjacent to NO.
If you require to adjust the settings for the selected
timer group then press the soft key adjacent to YES
and refer immediately to the REJECT TIMERS
section later in the manual.

Inverse Detection

This feature allows the action of the reject timer to be
reversed, such that the product containing no metal
contamination is rejected whilst metal contaminated
product is accepted.
The feature is often used to verify that a product
contains a metallic premium or free gift.
YES - YES to enable inverse detection for the
current product number and reverse the action of the
reject timer.
NO - Select NO to keep the reject timer in normal
mode.
Note:
This feature can only be selected when using a gated
timer.
42
OPERATING INSTRUCTIONS
4618 - 021