Safeline Signature Operating And Instruction Manual page 117

4)
a) If the display opposite appears, press the soft
key adjacent to NO.
else
b) Proceed to step 5).
5) Set the product line to its mid range speed.
6) Press the soft key adjacent to SIGNAL
SHIFT.
a) Place the metal contaminant at the rear /
trailing edge of the product.
b) Pass the product with the metal contaminant
attached through the detector aperture,
ensuring that the product does not slip or
skew.
c) Use the cursor Up and Down keys to adjust
the Signal Shift so that the reject device
operates just as the front edge of the pack
reaches the centre of the reject device.
7) Press the soft key adjacent to REJECT SHIFT.
a) Place the metal contaminant at the rear /
trailing edge of the product package.
b) Pass the product with the metal contaminant
attached through the detector aperture,
ensuring that the product does not slip or
skew.
c) Use the cursor Up and Down keys to adjust the
Reject Shift in a way that would reject the pack
if it was positioned correctly.
We are not attempting to reject the product at this
time !
8) Press the Enter key to accept the new settings.
9) Press the Enter key a second time to proceed to
the next display.
4618 - 021
OPERATING INSTRUCTIONS
101