Safeline Signature Operating And Instruction Manual page 153

1, 2
Command Direct
3
'z22' n
In
Description of the emulation commands
•
'z15' command: (enabled / disabled)
There are three modes of operations:
1. Emulation mode disabled
This represents the mode when no remote panel is used. The PCI protocol is unaffected.
(Default mode after hardware reset).
2. Normal Emulation mode
This mode of operation is achieved by using the emulation commands utilizing the existing protocol format.
(i.e. no alterations to the existing protocol format are required).
The additional commands to implement this mode are: 'z15', 'z20', 'z22'
Note: In this mode the 'z20' command works under the normal protocol format using ACK's and NAK's.
3. Fast emulation mode.
This mode makes use of the following commands: 'z15', z16', 'z20', 'z22'
In order to achieve a faster update rate, the 'z20' cmd works outside the normal protocol.
(All other commands use the normal protocol format).
4618 - 021
Description
Key pressed command
n = U: Up key
n = D: Down Key
n = L: Left key
n = E: Enter key
n = X: Recall key
n = M: Menu key
n = S1: Soft key #1
n = S2: Soft key #2
n = S3: Soft key #3
n = S4: Soft key #4
(See 'Emulation Mode' description for more details)
APPENDIX D
Notes
Normal & fast
emulation
mode
137