Safeline Signature Operating And Instruction Manual page 107

10) Ensure that the pack sensor beam is clear of
any packs or products.
11) Select the soft key adjacent to WINDOW TIME.
The display will show '-RUN-'.
12) Pass the product sample through the pack
sensor beam, ensuring that it does not skew or
slip on the conveyor.
The metal detector will automatically measure the
window time and display this instead of the '-RUN-'
message.
13) Repeat steps 11) and 12) to ensure that the
window time is being measured correctly and is
repeatedly calculating the same value, (within
±10%).
14) Ensure that the pack sensor beam is clear of
any packs or products.
15) Select the soft key adjacent to the SYNC.
DELAY.
When the Sync. delay is selected the detect led and
buzzer will sound permanently.
a) Pass the product through the detector
aperture, ensuring that the product does not
slip or skew.
b) Use the cursor Up and Down keys to adjust
the Sync Delay so that the pack is rejected
accurately and consistently.
16) Press the Enter key to accept the new settings.
17) Press the soft key adjacent to ETC.
4618 - 021
OPERATING INSTRUCTIONS
91