Safeline Signature Operating And Instruction Manual page 150

Command Identifier - 'z02'
The Automatic product-speed procedure can be started remotely by the host or from the front panel keypad, in either
case the front panel display and the communications commands will be in synchronization. When the host starts the
Automatic product-speed procedure remotely, with the command 'z02,1' given below, then the display will operate
just as if the Automatic product-speed procedure had been started from the front panel keyboard.
Commands the host may transmit:
The host can send any of the following messages :-
1,2
'z02, 1' This starts the automatic product-speed procedure operating for the current product number.
'z02?' This returns the current state of the automatic product-speed procedure (see the 'z02'n command
description below).
'z02,99' This command is sent when the host wishes to abort the automatic product-speed procedure and
return to normal operation. This is equivalent to pressing the front panel security keyduring the
automatic product-speed, and will cause the same action to occur in the metal detector.
Commands the metal detector may transmit
The following command will be transmitted in response to a 'z02?' command above, or automatically during the
operation of automatic product-speed.
'z02,' n n is a number indicating the state of the automatic product-speed's progress, the number, corresponds
with the displays on the front panel display as shown below.
Note the special case n = 0 means that automatic product-speed is not running.
Ensure nothing is
passing through aperture
Pass the test sample
through the aperture..
Product speed
adjustment completed
134
Automatic product speed procedure
'z02,1'
The test sample
is too large
'z02,2'
The test sample
was not detected
'z02,10'
The test sample is
too small
Product speed
adjustment failed
APPENDIX D
'z02,95'
'z02,97
'z02,98'
'z02,99'
4618-021