Safeline Signature Operating And Instruction Manual page 6

Safety Instructions
Most companies have a code of practice for their employees which is designed to ensure their safety in the working
environment. When new equipment is introduced it is important that operators, maintenance engineers and
supervisors are aware of the potential hazards.
The following guidelines must be followed by any person concerned with the operation, installation or handling of the
detector to ensure correct operation and to avoid any damage to the detector or to the person concerned.
WARNING
The equipment should only be used in accordance with the instructions given herein. Failure to comply with
these instructions may lead to the protection provided by the equipment becoming impaired.
Safeline will not be liable for incidental or consequential damage if the equipment is not installed in
accordance with the instructions given.
WARNING
On no account should any of the electrical panels of your detector be opened by anyone other than a
qualified electrical engineer. Voltages in excess of 30 volts rms or 50 volts DC. can, in certain
circumstances be lethal. When working on electrical or electronic equipment always follow current health
and safety practices and observe all other applicable regulations.
!
CAUTION
For correct operation and to prevent any damage to the detector follow the instructions given in this
document under the heading 'Installation'.
!
CAUTION
In accordance with EN 61010-1:1993 this equipment has been designed to be safe at least under the following
conditions:
Indoor use.
Altitude up to 2000m.
Storage temperature:
Operating temperature: -10 °C to +40 °C (15 °F to 110 °F)
Maximum relative humidity 93% for temperatures up to 45°C.
For connection to TN (EN60950:1992) power distribution systems only, for connections to other power distribution
systems please contact your supplier.
Mains supply voltage fluctuations not to exceed +10%/-15% of the nominal voltage.
Transient overvoltages according to INSTALLATION CATEGORY III.
Pollution degree 2 in accordance with IEC 664.
vi
-10 °C to +50 °C (15 °F to 120 °F)
PRELIMINARY PAGES
4618–021