Table of Contents
Advertisement
6
Maintenance
In this chapter you will find important information about
Inspection
Maintenance
Repair
of the milling machine.
ATTENTION!
Properly performed regular maintenance is an essential prerequisite for
operational safety,
failure-free operation,
a long working life of the milling machine and
the quality of the products which you manufacture.
Installations and equipment from other manufacturers must also be in good order and condition.
6.1
Safety
WARNING!
The consequences of incorrect maintenance and repair work may include:
Severe injuries of persons working on the milling machine,
damage to the milling machine.
Maintenance and repair work on the milling machine must be carried out by qualified
technical personnel only.
Validation
Check and maintain all safety-relevant stop, control and measuring devices (validation).
Documentation
Record all tests and works in a operator's log resp. log book.
6.1.1
Preparation
WARNING!
Only carry out work on the milling machine, if the main switch is switched off and
secured against restarting by means of a padlock.
Switching-off and securing the milling machine on page 15. Attach a warning label.
6.1.2
Restarting
Before restarting, run a safety check.
Safety check on page 14
WARNING!
Before starting the milling machine, it is essential that you ensure that this does not
constitute a risk to personal safety or damage to the milling machine.
Maintenance
Version 1.0.4 - 2020-08-04
Translation of original instruction
MT60
EN
55
Advertisement
Table of Contents
