Table of Contents
Advertisement
6.3
Inspection and maintenance
The type and level of wear depends to a large extent on the individual usage and operating
conditions. Any indicated intervals therefore are only valid for the corresponding approved con-
ditions.
Technical specification on page 18
Interval
Where?
Start of work,
after every
maintenance or
repair work
Start of work,
after every
maintenance or
repair work
Maintenance
Version 1.0.4 - 2020-08-04
What?
How?
Safety check on page 14
All mobile machine parts such as guides, feed screws,
spindle nuts must be oiled in regular intervals.
Always slightly oil bare surfaces.
Lubricate the cross table lifting spindle with bearing
grease.
Oil at these lubricating point positions.
Oiling
Img.6-1:
Translation of original instruction
Oiler cup
Oiler cup
MT60
EN
57
Advertisement
Table of Contents
