Optimum OPTImill MT 60 Operating Manual page 52

Parameter
1 - 3 0U_S
2 - 3 0U_S
3 - 3 0U_S
To set machining mode of the arc, use the numeric keys 0 or 1.
0 = Machining mode of the arc from the inside.
1 = Machining mode of the arc from the outside.
Confirm with the
Parameters
1 - 4 CU_d
2 - 4 CU_d
3 - 4 CU_d
To enter the diameter of the milling tool, use the numeric keys
and confirm with the
Parameter
1 - 5 S_Po
2 - 5 S_Po
3 - 5 S_Po
To enter the start position, use the numeric keys
and confirm with the
EN
DPA21
52
Description
Machining mode of the arc on the coordinate plane: X-Y
Machining of the arc on the coordinate plane: Y-Z
Machining of the arc on the coordinate plane: X-Z
key.
Description
Milling tool diameter: X-Y
Milling tool diameter: Y-Z
Milling tool diameter: X-Z
key.
Description
Start position: X-Y
Start position: Y-Z
Start position: X-Z
key.
Translation of original instruction
Operation
Version 1.0.4 - 2020-08-04