Intended Use - Optimum OPTImill MT 60 Operating Manual

Wear protective gloves!
Caution, danger of
explosive substances!
1.4

Intended use

WARNING!
In the event of improper use, the milling machine

may be a hazard to personnel,

the machine and other property of the operating company and

the functionality of the milling machine may be compromised.
The milling machine is designed and manufactured to be used for milling and drilling cold met-
als or other non-flammable materials or materials that do not constitute a health hazard when
commercial milling and drilling tools are used.
Using this machine it is possible to perform dry processing as well as processing by using cool-
ing lubricants.
The milling machine must only be installed and operated in a dry and well-ventilated areas.
The milling machine is designed and manufactured to be used in a non-explosive environment.
If the milling machine is used in any way other than described above, or modified without the
approval of Maschinen Germany GmbH, then the milling machine is being used improperly.
We will not be held liable for any damages resulting from any operation which is not in accord-
ance with the intended use.
We expressly point out that the guarantee or CE conformity will expire, if any constructive, tech-
nicalor procedural changes are not performed by the company Optimum Maschinen Germany
GmbH.
It is also part of the intended use that you
the limits of performance of the milling machine are observed,

the operating manual is observed,

the inspection and maintenance instructions are observed.

WARNING!
Extremely severe injuries due to non-intended use.
It is forbidden to make any modifications or alternations to the operating parameters
values of the milling machine. They could pose an accident hazard to persons and cause
damage to the milling machine.
EN
MT60
8
Warning: biological hazard!
Warning: danger of
slipping!
Translation of original instruction
Warning: suspended loads!
Protect the environment!
Warning of oxidizing
substances!
Contact address
Intended use
Safety
Version 1.0.4 - 2020-08-04