Maintenance; Safety; Preparation; Restarting - Optimum OPTImill BF 20V Operating Manual

6

Maintenance

In this chapter you will find important information about
Inspection

Maintenance

Repair

of the drilling-milling machine.
ATTENTION !
Properly performed regular maintenance is an essential prerequisite for
operational safety,

failure-free operation,

long service life of the drilling-milling machine and

the quality of the products which you manufacture.

Installations and equipment from other manufacturers must also be in good order and condition.
6.1

Safety

WARNING!
The consequences of incorrect maintenance and repair work may include:
very serious injury to personnel working on the drilling-milling machine,

damage to the drilling-milling machine.

Only qualified staff should carry out maintenance and repair work on the drilling-milling
machine.
6.1.1

Preparation

WARNING!
Only carry out work on the drilling-milling machine if it has been disconnected from the
mains power supply.

"Switching-off and securing the drilling-milling machine" on page 16
Attach a warning sign.
6.1.2

Restarting

Before restarting run a safety check.

"Safety check" on page 15
WARNING!
Before starting the drilling-milling machine, you must check that there is no danger for
persons and that the drilling-milling machine is not damaged.
Version 4.0.2 dated 2019-4-3 Translation of the original instructions
OPTIMUM
M A S C H I N E N - G E R M A N Y
BF20V | BF20L | BF20LD
®
GB
Page 43