Positioning To A Coordinate Point On The Arc - Optimum OPTImill MT 60 Operating Manual

Parameter
1 - 6 E_Po
2 - 6 E_Po
3 - 6 E_Po
To enter the end position, use the numeric keys and confirm with the
Parameters
1 - 7 CUF
2 - 7 CUF
3 - 7 CUF
To enter the machining depth, use the numeric keys and confirm with the
5.9.2

Positioning to a Coordinate Point on the Arc

Parameters
1Po
2Po
3Po
To select the desired coordinate point, press the
Press button
The machine axes will proceed until the positions of the selected coordinate axes read 0.000. Repeat
these steps until the arc has been completely machined.
INFORMATION
Press the button
display status. Press the 0 key again to continue with the function.
Press the button
Operation
Version 1.0.4 - 2020-08-04
Description
End position: X-Y
End position: Y-Z
End position: X-Z
Description
Machining depth: X-Y
Machining depth: Y-Z
Machining depth: X-Z
Description
Position: X-Y
Position: Y-Z
Position: X-Z
to select the desired coordinate point.
to temporarily interrupt the function. The display returns to the normal
to exit from the function.
Translation of original instruction
key.
key.
button.
DPA21 EN
53