Table of Contents
Advertisement
1.11
Personnel protective equipment
For some works you need personnel protective equipment as protective equipment.
Wear a safety helmet with facial protection when performing works where your face and eyes
are exposed to hazards.
Use protective gloves when handling pieces with sharp edges.
Use safety shoes when you assemble, disassemble or transport heavy components.
Use ear protection if the noise level (emission) in the workplace exceeds 80 dB (A).
Before starting work make sure that the prescribed personnel protective equipment is available
at the working place.
CAUTION!
Dirty or contaminated personnel protective equipment can cause diseases.
Clean it each time after use and once a week.
1.12
Safety during operation
We specially point out the specific dangers when working with and on the milling-machine.
WARNING!
Before activating the milling-machine assure yourself that this will neither endanger
other personnel nor cause damage to equipment.
Avoid any unsafe working practices:
Make sure that nobody is endangered by your work.
The instructions mentioned in these operating instructions have to be strictly observed dur-
ing assembly, operation, maintenance and repair.
Switch off the milling machine machine before measuring the workpiece.
Do not work on the milling-machine, if your concentration is reduced, for example, because
you are taking medication.
Observe the accident prevention regulations issued by your Employers Liability Insurance
Association or other competent supervisory authority, responsible for your company.
Inform the supervisor about all endangerments or errors.
Stay on the milling-machine until the movements are completely stopped.
Use the prescribed personnel protective equipment. Make sure to wear a well-fitting work
suit and, if necessary, a hairnet.
Switch off the milling machine on the main switch before changing the tool.
Use appropriate auxiliary materials to remove drilling and milling chips.
Make sure that nobody is endangered by your work.
Safely and firmly clamp the workpiece before switching on the milling machine.
Wear when working on the machine no jewelry, watches or rings.
1.13
Safety during maintenance
Inform the operators in good time about any maintenance and repair works.
Report all safety relevant changes and performance details of the milling-machine. Document
all changes, have the operating instructions updated accordingly and train machine operators.
GB
MT50
16
Translation of original operating manual
Version 1.2.8 - 2020-08-03
Advertisement
Table of Contents
