Maintenance; Safety; Preparation; Restarting - Optimum Optimill MH 50G Operating Manual

5

Maintenance

In this chapter you will find important information about
Inspection

Maintenance

Repair

of the milling machine.
ATTENTION!
Properly performed regular maintenance is an essential prerequisite for

operational safety,

failure-free operation,

a long working life of the milling machine and

the quality of the products which you manufacture.
Installations and equipment from other manufacturers must also be in good order and condition.
5.1

Safety

WARNING!
The consequences of incorrect maintenance and repair work may include:

extremely serious injuries to those working on the milling machine and

damage to the milling machine.
Maintenance and repair work on the milling machine must be carried out by qualified
technical personnel only.
5.1.1

Preparation

WARNING!
Only work on the milling machine if it has been disconnected from the power supply.

Switching-off and securing the milling machine on page 70
Attach a warning sign.
5.1.2

Restarting

Before restarting, run a safety check.

Safety check on page 69
WARNING!
Before starting the milling machine, it is essential that you ensure that this does not
constitute a risk to personal safety or damage to the milling machine.
5.2

Inspection and maintenance

The type and level of wear depends to a large extent on the individual usage and operating
conditions. Any indicated intervals therefore are only valid for the corresponding approved con-
ditions.
Version 1.0.5 - 2021-01-29 Translation of original instruction
MH50G│MH50V EN
95