4.10.3 Switching On The Rapid Taverse - Optimum OPTImill MT 60 Operating Manual

4.10.3 Switching on the rapid taverse

ATTENTION!
The rapid traverse is used exclusively to reach a position quick. The rapid traverse must
not be used as milling feed.

Set the selection lever for the table feed into the
"Rapid traverse" position
Neutral position
"Milling feed" position
Selection lever

Loosen clamping lever on the cross table.

In this context, absolutely pay attention that the clamping nuts of the adjustable end stop
switch are well tightened.

Turn the direction lever for table feed motion (X axis) to the required feed direction.
Mechanical end position stop
Direction lever

In order to switch off the rapid traverse, turn the direction lever for table feed motion to the
neutral position.
Operation
Version 1.0.4 - 2020-08-04
1
2
3
Img.4-7: Selector lever
Img.4-8: Direction lever
Translation of original instruction
1
position.
1
2
3
MT60 EN
35