Table of Contents
Advertisement
3. Using the Phillips #2 screwdriver, secure the VGA module to the system with the screw.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 26. Installing the VGA module
Next steps
1. Route the VGA cable, close the cable latch, and connect the VGA cable to the connector on the system board.
2. Route and connect the right control panel cable.
3. If removed,
install the air
4.
Install the backplane
cover.
5. If installed,
install the front
6. Follow the procedure listed in the
shroud.
bezel.
After working inside your system
on page 26.
Installing and removing system components
37
Advertisement
Table of Contents
