Table 26. BOSS S2 kit components
R6525 (quantity)
1
3
1
1
1
1 or 2*
1 or 2*
2
2
1
1
To remove the BOSS blank :
1. Power off the system and
2. Using the Phillips #1 screwdriver, remove the M3 x 0.05 x 4.5 mm screw that secures the BOSS blank to the PSU Bay. Slide
the BOSS blank away from the PSU Bay.
Figure 125. Removing the BOSS blank
To install the BOSS blank:
1. Power off the system and
2. Slide the BOSS blank on to the PSU bay until it is firmly seated. Using the Phillips #1 screwdriver, secure the BOSS blank
with the M3 x 0.05 x 4.5 mm screw.
128
Upgrade Kits
Components in kit
BOSS cover
M3 x 0.05 x 4.5 mm screws
BOSS signal cable
BOSS power cable
BOSS-S2 controller card module
BOSS-S2 card carrier
M.2 SSD
M.2 240 GB information label
M.2 480 GB information label
BOSS card filler
Tech sheet
remove the system
cover.
remove the system
cover.