Table of Contents
Advertisement
Figure 39. 4 x 3.5-inch drive backplane
1. BP_PWR_1 (backplane power and signal cable to system board)
Figure 40. 8 x 2.5-inch drive backplane
1. BP_PWR_1 (backplane power and signal cable to system board)
Figure 41. 10 x 2.5-inch drive backplane
1. DST_SA2 (backplane to front PERC)
3. DST_PA2 (PCIe/NVMe connector)
5. BP_PWR_1 (backplane power and signal cable to system
board)
7. DST_PB1 (PCIe/NVMe connector)
Removing the drive backplane
Prerequisites
CAUTION:
To prevent damage to the drives and backplane, remove the drives from the system before removing
the backplane.
CAUTION:
Note the number of each drive and temporarily label them before you remove the drive so that you
can reinstall them in the same location.
NOTE:
The procedure to remove the backplane is similar for all backplane configurations.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If installed,
remove the air
4.
Remove the drive backplane
5.
Remove all the
drives.
48
Installing and removing system components
Safety instructions
Before working inside your system
shroud.
cover.
2. DST_PB2 (PCIe/NVMe connector)
4. DST_SA1 (PERC to backplane)
6. DST_PA1 (PCIe/NVMe connector)
8. DST_PA3 (PCIe/NVMe connector)
on page 25.
on page 26.
Advertisement
Table of Contents
