Table of Contents
Advertisement
Figure 28. Removing the air shroud from the rear drive module
Next steps
1.
Replace the air
shroud.
Installing the air shroud
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
Steps
1. Align the slot on the air shroud with the standoff on the system.
2. Lower the air shroud into the system until it is firmly seated.
NOTE:
The air shroud is required for the standard heat sink configuration. For the L-type heat sink configuration, air
shroud is not supported.
Safety instructions
Before working inside your system
on page 25.
on page 26.
Installing and removing system components
39
Advertisement
Table of Contents
