Table of Contents
Advertisement
Figure 116. Removing the OCP card
Next steps
1.
Replace the OCP
card.
Installing the OCP card
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the expansion card
Steps
1. Open the blue latch on the system board.
2. Slide the OCP card into the slot in the system.
3. Push until the OCP card is connected to the connector on the system board.
4. Close the latch to lock the OCP card to the system.
Safety instructions
Before working inside your system
riser.
on page 25.
on page 26.
Installing and removing system components
115
Advertisement
Table of Contents
