Table of Contents
Advertisement
Figure 105. Installing the BOSS cover
2. Connect the BOSS power cable and BOSS signal cable to the BOSS S2 controller card module.
Figure 106. Connecting the BOSS power cable and BOSS Signal cable to the BOSS S2 controller card module
3. Slide the BOSS S2 controller card module into the BOSS module bay until it is firmly seated.
4. Using the Phillips #1 screwdriver, secure the BOSS S2 controller card module on the BOSS module bay with the two M3 x
0.05 x 4.5 mm screws. Connect the BOSS power cable and the BOSS signal cable to the system board.
Installing and removing system components
107
Advertisement
Table of Contents
