Figure 3-14: Cut the Panel
Slide the PC 5170 through the hole until the metal frame is flush against the
Step 3:
panel.
Insert the panel mounting clamps into the pre-formed holes along the edges of
Step 4:
the PC 5170, behind the metal frame. Refer to the mounting kit packing list for
the required number of mounting clamps.
Figure 3-15: Panel Mounting Clamp Positions
Tighten the screws that pass through the panel mounting clamps until the plastic
Step 5:
caps at the front of all the screws are firmly secured to the panel (Figure 3-16).
Page 62
PC 5170 Flat Panel PC
ACNODES ® Corp.
Step 0: