Hdd, Fdd And Cd Drive Installation; Hdd Installation; Figure 3-2: Hdd Retention Screws; Table 3-15: Lcd Voltage Setup Jumper Settings - Acnodes PC 5170 User Manual

JP2
1-2 closed
3-4 closed
5-6 closed

Table 3-15: LCD Voltage Setup Jumper Settings

3.6 HDD, FDD and CD Drive Installation

3.6.1 HDD Installation

To install a HDD, please follow the steps below:
Remove the back cover (Section 3.5.1).
Step 1:
The HDD bracket is attached to the elevated platform by four retention screws.
Step 2:
Remove the four retention screws from the elevated platform (Figure 3-2).

Figure 3-2: HDD Retention Screws

Attach the HDD bracket to the HDD. To do this, align the four retention screw
Step 3:
holes in both side of HDD bracket with the retention screw holes on the side of
the HDD. Insert two retention screws into the bracket on both sides of the HDD.
Install the HDD into the PC 5170 by aligning the retention screw holes in the
Step 4:
base of the HDD bracket with the retention screw holes on the elevated platform.
DESCRIPTION
+3.3V (default)
+5V
+12V
PC 5170 Flat Panel PC
Page 51