Operating System Software Installation Procedure - Mitsubishi Electric Q Series User Manual

5 START-UP PROCEDURES

5.3 Operating System Software Installation Procedure

The operating system software must be installed to the Motion controller by using the
peripheral device and MT Developer2.
The installation procedure is shown below.
Set a rotary switch1 (SW1) of Motion
controller to "A".
(Rotary switch 2 (SW2) is optional.)
Turn ON the Motion controller's power
supply.
Start the install of MT Developer2.
Set the connection method between
the personal computer and Motion
controller in the Transfer Setup.
Operation in
MT Developer2
Select the operating system software
(Note)
installed, and install it in the Motion
controller.
Dialog "Installation is completed" is
displayed.
Turn OFF the Motion controller's
power supply.
Set a rotary switch1 (SW1) and
switch2 (SW2) of Motion controller to
"0".
(Note): Install the operating system software by screen of MT Developer2.
Refer to help of MT Developer2 for details.
START
Factory default in SW1 "A",
SW2 "0" position.
END
5 - 7
Set to installation mode.
Refer to Section 2.5.1(6) for rotary switch.
Steady "INS" display.
RUN/STOP is ignored.
The operating system software can be
installed normally by dialog display.
Set to mode operated by RAM.