Mitsubishi Electric Q Series User Manual page 42

2 SYSTEM CONFIGURATION
Part name Model name
QC05B
QC06B
QC12B
Extension cable
QC30B
QC50B
QC100B
MR-J3BUS M
SSCNET cable
MR-J3BUS M-A
MR-J3BUS M-B
(Note-5)
(Note-1) :
(Note-2) : The manual pulse generator or incremental synchronous encoder that consumes less than 0.2[A] of
(Note-3) : Be sure to use the cable for forced stop input (sold separately). The forced stop cannot be released
(Note-4) : 5VDC internal current consumption of shared equipments with PLC might be changed.
(Note-5) : Please contact your nearest Mitsubishi sales representative for the cable of less than 30m(98.43ft.).
Motion controller related module (continued)
(Note-1)
Length 0.45m(1.48ft.)
Length 0.6m(1.97ft.)
Length 1.2m(3.94ft.)
Length 3m(9.84ft.)
Length 5m(16.40ft.)
Length 10m(32.81ft.)
• Q170MCPU
• Standard cord for inside panel
0.15m(0.49ft.), 0.3m(0.98ft.), 0.5m(1.64ft.), 1m(3,28ft.), 3m(9.84ft.)
• Q170MCPU
• Standard cable for outside panel
5m(16.40ft.), 10m(32.81ft.), 20m(65.62ft.)
• Q170MCPU
• Long distance cable
30m(98.43ft.), 40m(131.23ft.), 50m(164.04ft.)
=Cable length (015: 0.15m(0.49ft.), 03: 0.3m(0.98ft.), 05: 0.5m(1.64ft.), 1: 1m(3.28ft.), 2: 2m(6.56ft.),
3: 3m(9.84ft.), 5: 5m(16.40ft.), 10: 10m(32.81ft.), 20: 20m(65.62ft.), 25: 25m(82.02ft.),
30: 30m(98.43ft.), 40: 40m(131.23ft.), 50:50m(164.04ft.)
current can be connected to the internal I/F connector.
without using it.
Cable for forced stop input is not attached to the Motion controller. Please purchase the cable for length
according to system separately.
Be sure to refer to the MELSEC-Q series PLC Manuals.
Description
MR-J3(W)- B/MR-J3(W)- B
MR-J3(W)- B/MR-J3(W)- B
MR-J3(W)- B/MR-J3(W)- B
2 - 13
Current
consumption
5VDC[A]
——
MR-J3(W)- B
——
MR-J3(W)- B
——
MR-J3(W)- B
——
Remark