To Adjust The Line Thickness - Toshiba e-STUDIO2010AC Imaging Manual

3.Printer-specific Adjustments
3.6.3

To Adjust the Line Thickness

Before adjustment
 Explanation
You can improve the following symptoms by adjusting the line thickness.
• The thickness of printed lines differs from that displayed on the screen.
• Barcode lines are blurred.
• Lines are dotted since they are too much thin.
 Procedures
You can start from any of the procedures. Adjustment results of procedures (4) and (5) also affect other
unintended things.
(1) Enable the "Distinguish Thin Line" checkbox on the printer driver.
This adjustment is effective when lines have been dotted since they are too much thin.
"3.1.7 Graphic Line Width Adjustment"
• You cannot make lines thinner.
(2) Change the image type.
By selecting "General", thin lines are reproduced darkly and clearly. By selecting "Line Art", the
difference of the line width is reproduced expressly.
For details on how to make the change, refer to "3.2 To Make Print Suitable for the Original".
(3) Perform sharpness adjustment.
By enhancing the sharpness, the text and lines will become thicker.
For details of the adjustment procedure, refer to "3.1.4 Sharpness Adjustment".
* This adjustment will be reflected only when printing is performed by selecting "600 dpi".
(4) Perform blurred text in black adjustment.
By performing this adjustment, a blurred barcode sometimes becomes readable.
For details of the adjustment procedure, refer to "3.1.8 Blurred Text in Black Adjustment".
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
After adjustment
© 2018 TOSHIBA TEC CORPORATION All rights reserved
3-68