Toshiba e-STUDIO2010AC Imaging Manual page 90

2.Copier-specific Adjustments
(4) Select [05 ADJUSTMENT MODE] and arrange the color balance by changing the setting values for
the codes from [7960] to [7987] to adjust the density for each color.
Original Color to
mode adjust
Y (Yellow)
M (Magenta) 05-7965
Text/Photo
C (Cyan)
K (Black)
Y (Yellow)
M (Magenta) 05-7966
Text
C (Cyan)
K (Black)
Y (Yellow)
M (Magenta) 05-7967
Printed Image
C (Cyan)
K (Black)
Y (Yellow)
M (Magenta) 05-7968
Photo
C (Cyan)
K (Black)
Y (Yellow)
M (Magenta) 05-7969
Map
C (Cyan)
K (Black)
Y (Yellow)
M (Magenta) 05-7981
User Custom
C (Cyan)
K (Black)
Y (Yellow)
M (Magenta) 05-7985
Red Seal Color
C (Cyan)
K (Black)
• Set the value in increments of approximately 10, while checking the copy image until the optimum
value is obtained.
• The setting value "25" corresponds to one step in the background adjustment on the control
panel.
• The value for the code corresponding to the original mode (Text/Photo, Text, or Printed Image) will
affect the copy image quality in the Full color mode and the Auto Color mode.
• The subcode varies according to the area where the density is adjusted. Refer to the table below
and set the subcode for the area to be adjusted. The background (highlight) density will vary, if the
low or middle density area is mainly adjusted. Adjusting the subcode 2 allows you to adjust the
high density area. But it will not affect the background density. Therefore, never change the value
for the high density area.
Subcode
0
1
© 2018 TOSHIBA TEC CORPORATION All rights reserved
[05] code Subcode Recommended value
05-7960 0/1
0/1
05-7970 0/1
05-7975 0/1
05-7961 0/1
0/1
05-7971 0/1
05-7976 0/1
05-7962 0/1
0/1
05-7972 0/1
05-7977 0/1
05-7963 0/1
0/1
05-7973 0/1
05-7978 0/1
05-7964 0/1
0/1
05-7974 0/1
05-7979 0/1
05-7980 0/1
0/1
05-7982 0/1
05-7983 0/1
05-7984 0/1
0/1
05-7986 0/1
05-7987 0/1
Area where the density is adjusted
Low density area
Middle density area
2-36
Set a value larger than
128 to increase the
density.
Set a value smaller than
128 to decrease the
density.
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
Acceptable
Default
value range
0 to 255 128