Toshiba e-STUDIO2010AC Imaging Manual page 61

(7) Select [05 ADJUSTMENT MODE]. Change the values for codes [7187] and [7189] to [7193] to
adjust the gamma balance in each of middle and high density areas.
Original mode [05] code
Drop Out Color
User Custom
Text / Photo
Text
Photo
Image smoothing
• Set the value in increments of approximately 20, while checking the copy image until the optimum
value is obtained.
(Please be careful because the gradation (or density) of the middle density area may exceed that
of the high density area, depending on the setting value.)
• The subcode varies according to the area where the density is adjusted. Refer to the table below
and set the subcode for the area to be adjusted. The density of light text or a graphic image will
vary, if the middle or high density area is mainly adjusted. Adjusting the subcode 0 allows you to
adjust the low density area. But it will not affect the light text or graphic images. Therefore, never
change the value for the low density area.
Subcode
1
2
(8) Select [05 ADJUSTMENT MODE] and change the setting values for the codes [7218] and [7219] to
set up the light emission level, resulting in the text density adjustment.
Original mode [05] code
Text / Photo 05-7218
Text 05-7219
• Set a value larger than the default one to increase the density.
• Set a value smaller than the default one to decrease the density.
After changing the value, make a copy and check the image quality.
If further image quality adjustments are necessary, reset all the values changed in steps (1) to (8)
above to the default ones and then follow the next step.
© 2018 TOSHIBA TEC CORPORATION All rights reserved
Subcode
05-7187 To make the copy density
darker: Set a value larger
05-7189
05-7190
1/2
05-7191
To make the copy density
05-7192
05-7193
Area where the density is adjusted
Meddle density area
High density area
Acceptable
Subcode
value range
3
0 to 255
4
3
0 to 255
4
2-7
Recommended value
value range
than 128.
lighter: Set a value
smaller than 128.
Default Density area to be adjusted
191
255 Maximum density area (solid)
191
255 Maximum density area (solid)
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
2.Copier-specific Adjustments
Acceptable
Default
0 to 255 128
High density area
High density area