To Adjust The Density On A Solid Colored Image - Toshiba e-Studio6506AC Imaging Manual

1. General Adjustments – Copying, Printing and e-Filing (Output from Box)

1.2 To Adjust the Density on a Solid Colored Image

If the density is decreased
The solid colored area becomes lighter.
 Explanation
The density of a certain color can be made darker or lighter in accordance with the type of paper or the content of
an original.
When the toner amount on solid areas must be adjusted as requested by a user, an image quality target value or
developer bias must be adjusted.
The correction amount needed varies depending on the status of use of the consumables such as the developer
material or the drums, or the status of the installation site.
Since a constant value will be applied regardless of the influences of the above status in the developer bias
adjustment, perform image quality adjustment while changing the target value as much as possible.
 Procedures
* The service technician must perform the adjustment in accordance with the procedures below.
(1) Select [05 ADJUSTMENT MODE]. Adjust the density of the copied or printed solid image.
• Use steps (a) to (b) to perform the adjustment.
(a)Select [05 ADJUSTMENT MODE] and change the value for code [2662] to correct the image quality target value.
Color to
[05] Code
adjust
Y (Yellow)
M (Magenta)
C (Cyan)
K (Black)
*When the value becomes larger than the present one, and the solid image becomes darker. When it
becomes smaller, the image becomes lighter.
The value must fall within a range of -50 and +50 from the default.
e-STUDIO5506AC/6506AC/7506AC (Ver01)
Subcode
0
1
05-2662
2
3
1 - 6
If the density is increased
The solid colored area becomes darker.
Default
343
340
369
360
© 2016, 2017 TOSHIBA TEC CORPORATION All rights reserved