To Adjust The Density On A Solid Colored Image - Toshiba e-STUDIO2010AC Imaging Manual

1.2

To Adjust the Density on a Solid Colored Image

If the density is decreased
The solid colored area becomes lighter.
 Explanation
The density of a certain color can be made darker or lighter in accordance with the type of paper or the
content of an original. When the toner amount on solid areas must be adjusted as requested by a user,
an image quality target value or developer bias must be adjusted. The correction amount needed varies
depending on the status of use of the consumables such as the developer material or the drums, or the
status of the installation site. Since a constant value will be applied regardless of the influences of the
above status in the developer bias adjustment, perform image quality adjustment while changing the
target value as much as possible.
 Procedures
The service technician must perform the adjustment in accordance with the procedures below.
(1) Select [05 ADJUSTMENT MODE]. Adjust the density of the copied or printed solid image.
Use steps (a) to (b) to perform the adjustment.
(a) Select [05 ADJUSTMENT MODE] and change the value for code [2662] to correct the image
quality target value.
Color to
[05] Code
adjust
Y (Yellow)
M (Magenta)
05-2662
C (Cyan)
K (Black)
• When the value becomes larger than the present one, and the solid image becomes darker.
When it becomes smaller, the image becomes lighter. The value must fall within a range of "-
50" and "+50" from the default.
© 2018 TOSHIBA TEC CORPORATION All rights reserved
1.General Adjustments – Copying, Printing and e-Filing (Output from Box)
The solid colored area becomes darker.
Subcode
e-STUDIO2010AC/
2510AC
0 322
1 312
2 327
3 333
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
1-7
If the density is increased
Default
e-STUDIO2515AC/3015AC/
3515AC/4515AC/5015AC
333
337
369
349