Toshiba e-STUDIO2010AC Imaging Manual page 36

1.General Adjustments – Copying, Printing and e-Filing (Output from Box)
 Caution after the adjustment
• The adjustment may possibly slow down the copying or printing speed, extend the warm-up time when
the MFP is returned from the auto power save mode, and shorten the life of the consumables,
because of an increase in the number of times image quality control is performed. Therefore, carefully
perform the adjustment, while checking the copy or print image.
• Note the following when you print in [Thick 1] paper mode in step (2):
• Printing speed decelerates to 17.5 sheets per minute (A4/LT) after the adjustment.
• The [Thick 1] paper mode cannot be set for the LCF (Large Capacity Feeder, optional). Therefore
the maximum number of sheets acceptable for continuous printing should be the one for the
drawer. However in the copying mode, you can set the [Thick 1] paper mode to more than one
drawer and copy more paper continuously with the automatic drawer change function.
• The density level of the Low/Middle density image may differ from that of the [Plain] paper mode
after the adjustment.
• The PM counter value increases by 2 counts for 1 sheet of [Thick 1] paper.
 Remarks
• Enter the value mentioned in the procedures or one within the recommended value range for the
adjustment. Otherwise, it may cause a loss in MFP performance, including slowdown in the copying or
printing speed.
• When replacing any consumable, refer to the relevant information in the Service Manual.
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC © 2018 TOSHIBA TEC CORPORATION All rights reserved
1-24