Toshiba e-STUDIO2010AC Imaging Manual page 26

1.General Adjustments – Copying, Printing and e-Filing (Output from Box)
Paper type
Plain/Thick
paper
Thick paper 1
Thick paper 2
Thick paper 3*
Special paper 1
Black Back
Special paper 2
Recycled paper
Thick paper 4*
Thin paper*
Envelope
Special paper 3*
• "Front" refers to the printed side in the simplex mode or the side that is delivered facing
downwards in the duplex mode.
"Back" refers to the printed side that is delivered facing upwards in the duplex mode.
• The table below shows you the acceptable paper weight for the paper type.
Paper type
Plain paper
Thick paper
Thick paper 1
Thick paper 2
Thick paper 3*
Thick paper 4*
Thin paper*
* e-STUDIO2515AC/3015AC/3515AC/4515AC/5015AC only
• After adjusting the transfer roller bias output, perform automatic calibration.
For further information regarding the procedures, refer to procedure (1) in "1.1 To Obtain a Darker
Image".
<Hint>
• The transfer voltage increases as the setting value is increased. It is usually desirable that the
setting value be decreased to obtain a clearly highlighted area.
After performing the adjustment, print and check the image quality.
If further image quality adjustment is necessary, go to step (3).
(2) If the image on the high density area looks grained on plain paper other than the TOSHIBA-
recommended one is used, select "recycled paper" as a paper type.
To select the paper type, refer to the Operator's Manual for Paper Preparation Guide.
• If fine adjustment of image quality in the recycled paper mode is required in accordance with the
paper type, follow the steps from (a) to (b) below.
(a) Select [05 ADJUSTMENT MODE]. Change the value of the codes [2934] to [2937] to adjust
(2nd) transfer bias output. (In this step the transfer roller bias offset voltage is adjusted to
print the high density area or the Low/Middle density area of the image most clearly.)
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
Sub
[05] code
code
0
1
2
3
5
05-2937
6
7
8
9
10
11
Acceptable paper weight
60 to 80 g/m²
81 to 105g/m²
106 to 163 g/m²
164 to 209 g/m²
210 to 256 g/m²
257 to 280 g/m²
52 to 59 g/m²
1-14
Recommended Acceptable
value value range
2 to 8 0 to 10
16 to 21 lb. Bond
22 to 28 lb. Bond
Max. 60 lb. Cover
Max. 110 lb. Index
Max. 140 lb. Index
Max. 100 lb. Cover
14 to 16 lb. Bond
© 2018 TOSHIBA TEC CORPORATION All rights reserved
Default
5