To Adjust Printing Positions On Front And Back Sides In The Duplex Mode - Toshiba e-STUDIO2010AC Imaging Manual

1.6 To Adjust Printing Positions on Front and Back Sides in
the duplex mode
 Explanation
The printing positions on the front and back sides of business cards may deviate. The amount of this
deviation can be reduced with image position or image distortion adjustment.
 Procedures
The service technicians must perform all adjustments in accordance with the procedures below.
(1) Overview of adjustment
The adjustment is divided into 3 major categories noted below. The points for each adjustment are
as follows:
(a) Image position adjustment: Adjust values as closely as you can to the target value (±0).
(To make printing positions as precise as possible)
(b) Image distortion adjustment: Adjust the image distortion that is not susceptible to the self-
diagnostic codes by using the hardware.
(To make printing positions as precise as possible)
(c) Fine image positions adjustment: Adjust the image positions finely to place the images on
both sides in their optimal positions.
(2) (a) Image position adjustment
Refer to the "6.1.7 Image dimensional adjustment at the printing section" of the Service Manual and
adjust the image positions by approximating values from [A] to [F] below to a target value (±0) as
closely as possible.
Items
[A] Reproduction ratio of the primary
scanning direction
[B] Primary scanning data writing start
position
[C] Reproduction ratio of the secondary
scanning direction (Fine adjustment of
transfer belt motor rotation speed)
[D] Secondary scanning data writing
start position
[E] Primary scanning data writing start
position at duplexing
[F] Secondary scanning data writing
start position at duplexing
*1: e-STUDIO2515AC/3015AC/3515AC/4515AC/5015AC only
*2: Use this chart to adjust the void width match.
© 2018 TOSHIBA TEC CORPORATION All rights reserved
1.General Adjustments – Copying, Printing and e-Filing (Output from Box)
Adjustment
Chart
Tolerance
*1
200 ± 0.5 mm
05-98
52 ± 0.5 mm
200 ± 0.5 mm
05-98
52 ± 0.5 mm
52 ± 0.5 mm
05-3
52 ± 0.5 mm
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
1-29
Adjustment
Chart
Tolerance
*1
4.2 ± 0.5 mm
05-315
4.2 ± 0.5 mm
*2 4.2 ± 0.5 mm
05-315
4.2 ± 0.5 mm
4.2 ± 0.5 mm
*2
05-316
4.2 ± 0.5 mm