Toshiba e-STUDIO2010AC Imaging Manual page 243

To adjust the image quality on Black and White printing
("Black and White" is selected from among the "Color" options on the PCL or PS or XPS printer
driver. "Mono" is selected from among the "Color Type" options on Mac.)
• The "Color" options are available in the "Basic" tab on the PCL, PS and XPS printer drivers.
The "Color Type" options are available in the "Color Settings 1" menu in the print dialog box on
Mac.
(a) Select [05 ADJUSTMENT MODE]. Increase the value for codes [7307] or [7302] to adjustment
the upper limit of the image density in the toner save mode.
• Printing on Mac is performed in PostScript. (See the "PS" row in the table below.)
Resolution
600 dpi
1200 dpi
• Set the value in increments of approximately 30, while checking the printouts until the
optimum value is obtained.
 Caution after the adjustment
The adjustment may possibly cause an increase of the amount of toner used (if the image density is
increased) or provide faint print images (if the image density is decreased). Therefore, carefully perform
the adjustment, while checking the printouts.
© 2018 TOSHIBA TEC CORPORATION All rights reserved
PDL [05] code Subcode
PS 05-7307 0
PCL 05-7307 1
XPS 05-7307 2
PS 05-7302 0
3-83
3.Printer-specific Adjustments
Recommended
value value range
Set a value smaller
than 176 to decrease
the density.
Set a value larger
than 176 to increase
the density.
Set a value smaller
than 176 to decrease
the density.
Set a value larger
than 176 to increase
the density.
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
Acceptable
Default
0 to 255 176
0 to 255 176