To Copy Sharply (To Enhance Sharpness) - Toshiba e-STUDIO2010AC Imaging Manual

2.10

To Copy Sharply (To enhance sharpness)

Before adjustment
The image looks light and blurred on the
copy.
 Explanation
Perform adjustment regarding image processing (sharpness intensity), in order to obtain a sharper copy
image, when a light or blurred original is copied.
 Procedures
• You can start with any of the procedures. But it is recommended to perform the procedures in order, as
listed below. You can perform one procedure in conjunction with another. But if this changes the image
quality more than required or loses the effectiveness of the adjustment, restore the settings made in
the previously performed procedure to the original ones. Then perform other procedures.
• Both the service technician and the user can perform procedures (1) and (2).
• Only the service technician must perform procedure (3).
(1) Press [Image] tab on the Copy mode. Press [One Touch Adjustment].
Press [Clear] and then press [OK].
After selecting the "Clear" option, copy and check the copy image quality.
When the copy image quality with the "Clear" option selected is insufficient, cancel the "Clear" option
and perform the next procedure.
(The one-touch adjustment can be canceled by pressing [Reset].)
(2) Press [Image] tab on the Copy mode. Press [Sharpness].
Press [Sharp] to increase the sharpness intensity.
After increasing the sharpness intensity, copy and check the copy image quality.
If further image quality adjustment is necessary, go to the next step.
© 2018 TOSHIBA TEC CORPORATION All rights reserved
After adjustment
The edges are enhanced and the copy
image becomes sharper.
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
2-47
2.Copier-specific Adjustments