Xilinx Zynq-7000 User Manual page 4

Date Version
11/12/2012 2.1
11/19/2012 2.1.1
01/31/2013 3.0
Zynq-7000 AP SoC ZC702 Base TRD
UG925 (v6.0) February 21, 2014
Updated for ISE® Design Suite 14.3.
Chapter 1, Introduction: Document and web site references changed throughout
the book. In Base TRD Key Features, page
removed.
Chapter 2, Functional Description:
values changed. Table 2-2
RGB2YUV block was removed. In
PERF_MON_HP0, PERF_MON_HP2, VTC_0, and DVI2AXI_0 sections changed. The
dvi2axi Converter heading changed to dvi2axi on page 25.
replaced and a GUI explanation added.
GUI mode. In section Graphical User Interface, page
Command Line Shell paragraphs were removed. The directory structure changed
in Figure C-1.
Appendix F, Additional Resources: Appendix was reorganized. A link was added
for the Master Answer Record for the ZC702 board.
Appendix G, Regulatory and Compliance
Conformity link was added.
Made typographical edits.
Updated for ISE® Design Suite 14.4.
Chapter 2, Functional Description:
Monitor and TPG_0 areas.
23,881 to 24,094, and % of Used 35 to 37.
and renamed next row to PERF_MON_HP2_HP0_HP2.
Cortex-A9 Core section added "For this TRD, both ARM cores run at 667 MHz."
Table 2-6, PERF_MON_HP0 changed to PERF_MON_HP0_HP2. In that same
section added new row SLOT_1_AXI_ACLK 150 0 Yes clk_150mhz and removed
PERF_MON_HP2 section. In TPG_0 section, changed clk to aclk, 148 to 150,
video_clk_int to clk_150mhz, S_AXI_ACLK to s_axi_aclk, and DVI2AXI_0 section to
VID_IN_AXI4S. Reset Module changed to
page 22. AXI VDMA Video Direct Memory Access, page 21 changed to
Direct Memory Access. Heading VTC on page 22 changed to
Controller. In the same section, VTC IP in last paragraph changed to "Video
Timing Controller IP." Added final sentence in that section "For detailed
information on ...". The TPG section changed to
Section logiCVC-ML, page 25
added the final sentence, "For more information..." In
page 26 edited the last sentence and added "and licensing information ..."
Performance Monitor, page 25
dropped 's' at Instance. The last sentence in the same section changed from "Two
AXI Performance Monitors are instantiated" to "Two slots of AXI Performance
Monitors are used." Video Multiplexer, page 26
detailed information ..." The dvi2axi section on page 25 was removed.
changed "Xilinx DMA" block to "Xilinx AXI VDMA."
to "Xilinx AXI VDMA." XVDMA Driver, page 35
AXI VDMA." XFILTER_STOP, page 31
"Continuous mode" in both sentences.
sentence at end "The Linux kernel is in SMP mode and both ..."
Figure 2-7 were replaced. In
"Sobel Filter (using the xFilter driver)" was added. In
page 44 deleted "Sobel filter" bullet.
www.xilinx.com
Revision
11, 1 GB DDR3 running at 533 MHz was
Figure 2-1 line colors changed.
Peripheral names changed. Under
Table 2-6, the processor is ps7_0, and
Figure 2-7 was added to show minimized
Information: A Declaration of
Figure 2-1 was changed in the Performance
Table 2-1 changed Used 19,052 to 19,805, 42 to 43,
Table 2-2, deleted PERF_MON_HP2 row
Processor System Reset Module,
Test Pattern Generator, page
was added. In AXI Performance Monitor, page 25
changed Instance: PERF_MON_HP0_HP2 and
added the final sentence "For
Table 2-9
changed "Xilinx DMA" to "Xilinx
bullet switched "On demand mode" with
Application, page 40
Control and Decision Making, page 43
Table 2-1 cell
Clocking, page 19,
Figure 2-6 was
41, the File Browser and
APU, page 17, end of
AXI Video
Video Timing
24.
Chroma Resampler,
AXI
Figure 2-4
changed "core DMA"
added a new
Figure 2-6 and
the bullet
User Space Device Control,
4