BRP Rotax 915 i A Series Maintenance Manual page 73

NOTE
Due to limited tolerances, it may be difficult to push the drive gear onto the end of
the crankshaft. If necessary, turn it and push it on in another position.
Step
Figure 5.7
Step
NOTE
If there is slight vertical run-out, replace the nut and repeat the measurement.
Effectivity: 915 i A Series
Rev. 1
BRP-Rotax
MAINTENANCE MANUAL LINE
Procedure
2 Secure the Hex. nut M30x1,5 with LOCTITE 648 and screw it counter
clockwise left hand threads onto the crankshaft along with the friction
washer VS-30. Tightening torque 300 Nm (221 ft.lb.).
5
4
1
Crankshaft (power take off side)
1
3 Crankshaft
5 VS-30 friction washer
The sealing surface must be free from dirt and oil.
Procedure
3 Inspect the run-out. See also
(CS24)
2
3
6
Drive gear
2
4 Hex. nut
6 Serial number
ATTENTION
Chapter 72-10-00 section Wear limits.
09588
05–50–00
Page 9
June 01 2019