Oil Specification Not Respected - BRP Rotax 915 i A Series Maintenance Manual

OIL SPECIFICATION NOT RESPECTED

General note
NOTE
An entry by the pilot in the engine log book of all pertinent details is required.
If by error engine was serviced with oil, which does not correspond with oil specification in
the Operators Manual and the engine has been in operation for less than 5 hours, the fol-
lowing measures must be taken:
Less than 5 hr.
Step
05–50–00
Page 26
June 01 2019
BRP-Rotax
MAINTENANCE MANUAL LINE
Oil specification not respected
Procedure
1 Oil change.
2
Remove the lowest positioned banjo screw (1) (banjo bolt, plug screw or
screw socket) and drain the remaining oil from the crankcase. Screw in
banjo bolt or plug screw.
Tightening torque see Installation Manual for the engine type
915 i A Series.
3 Replace oil filter.
4 Drain oil completely from oil cooler.
5
Drain oil from oil tank.
6 Refill oil tank with oil as specified, refer to Operators Manual.
7 Purge air from oil system.
See Chapter 12-20-00 section Purging the oil system.
8 Run engine for approx. 1 hour and change oil and oil filter once more, see
Chapter 12–20–00 section Oil change.
Effectivity: 915 i A Series
Rev. 1