BRP Rotax 915 i A Series Maintenance Manual page 68

When removing the propeller gearbox, take care not to damage the bearing point
and the oil seal running surface (on the roller bearing side) of the propeller shaft.
Figure 5.2: TYPICAL
Step
Overload clutch, torsion shaft and propeller shaft are installed in splines only, they can
05–50–00
Page 4
June 01 2019
BRP-Rotax
MAINTENANCE MANUAL LINE
Hex./Torx-flange screw M8x45
1
Procedure
4
Install puller part no. 877660 onto the two threaded bolts M8 of the gear
cover.
5 The entire propeller gearbox can now be pulled off by moving the handle
of the special tool part no. 877660 without damaging the ball bearing or
propeller shaft.
Non-compliance can result in serious injuries or death!
and will separate from removed gearbox.
ATTENTION
Sk/Torx-flange screw M6x40
2
m WARNING
Effectivity: 915 i A Series
Rev. 1