Installation Of Propeller Gearbox - BRP Rotax 915 i A Series Maintenance Manual

INSTALLATION OF PROPELLER GEARBOX

Preparation
• Clean and degrease all parts carefully.
• Remove LOCTITE adhesive residue with LOCTITE 7063 or equivalent.
• Visual inspection of the crankshaft on the power take off side.
Figure 5.6
Step
05–50–00
Page 8
June 01 2019
BRP-Rotax
MAINTENANCE MANUAL LINE
The drive gear must only be pushed on manually.
Ensure that the friction washer is in the correct installation position.
The dog and drive gears are in pairs.
Only use parts with the same serial number.
Crankshaft (power take off side)
1
3 Friction washer VS-30
Procedure
1 Push the drive gear onto the crankshaft.
ATTENTION
No hammering or pressing!
ATTENTION
ATTENTION
Drive gear
2
4 Hex. nut
Effectivity: 915 i A Series
Rev. 1