Turbocharger; Checking And Cleaning Plug Screw (Turbo Oil Sump Assy.) - BRP Rotax 915 i A Series Maintenance Manual

Checking the
Step
waste gate lever
Figure 7.20: Turbocharger

CHECKING AND CLEANING PLUG SCREW (TURBO OIL SUMP ASSY.)

Procedure To checking and cleaning the following steps are necessary:
See Figure
Step
12–20–00
Page 44
June 01 2019
BRP-Rotax
MAINTENANCE MANUAL LINE

TURBOCHARGER

Procedure
1 Check the waste gate lever for free movement. If it does not move freely,
lubricate the axle of the waste gate with LOCTITE ANTI SEIZE 15378.
.7.21
Procedure
1 Loosen the plug screw assy. M22x1.5 (1) with the O-ring 18x2.5 (2)
2 Drain the residual oil from the oil sump assy.
3
Inspect the plug screw assy. of metal particals.
4 Clean the plug screw with suitable clean agent.
5
Install plug screw assy. M22x1.5 with O-ring 18x2.5 into the oil sump assy..
6 Tightening torque 20 Nm (15 ft.lb).
Effectivity: 915 i A Series
Rev. 1