Oil Change - BRP Rotax 915 i A Series Maintenance Manual

OIL CHANGE

Instruction
NOTE
Run engine to warm oil before beginning oil change procedure. To change the oil
the following steps are necessary:
Step
Only use brand name oil in accordance with the latest Operators Manual and the
The engine must not be cranked when the oil system is open. Attention must also
DO NOT use compressed air to blow through the oil system (or oil lines, oil cool-
ENVIRONMENTAL NOTE
Do not harm the environment by spilling oil. Dispose of oil in an environmentally friendly
Effectivity: 915 i A Series
Rev. 1
MAINTENANCE MANUAL LINE
Procedure
1
Crank engine slowly by hand to transfer the oil from the crankcase.
See Chapter 12-20-00 section Purging the oil
2 Remove safety wire and oil drain screw from the oil tank, drain the used oil -
see environment note.
3 Replace oil filter at each oil change and inspect the filter matt.
See Chapter 12-20-00 section Oil filter replacement and Inspection of the
filter insert.
4 Dispose of oil filter according to environmental regulations.
5 Install oil drain screw with new gasket and safety wire.
latest Service Instruction "Selection of suitable operating fluids" of the respec-
be paid to this before first commissioning (e.g. when assembling the propeller
after correct purging of the oil system).
er, oil pump housing, oil bores in the engine).
BRP-Rotax
ATTENTION
tive engine type.
ATTENTION
ATTENTION
Protect the environment.
manner.
system.
12–20–00
June 01 2019
Page 27