Installing New Oil Filter - BRP Rotax 915 i A Series Maintenance Manual

INSTALLING NEW OIL FILTER

Procedure To mount the oil filter the following steps are necessary:
Step
Figure 7.15: Install oil filter
12–20–00
Page 32
June 01 2019
BRP-Rotax
MAINTENANCE MANUAL LINE
Procedure
1 Clean the contact surface (1) of the oil pump housing (2) with a clean cloth.
2 Apply thin film engine oil on the gasket (3) of the oil filter (4).
3 Install the oil filter on the engine.
4 Screw on oil filter until oil filter gasket is seated solidly.
NOTE
Mark 270° - check mark on oil pump housing to control tightening of
oil filter.
5
Tighten oil filter with 3/4 turn (270°).
6 Inspection of the used oil filter.
See Chapter 12-20-00 section Inspection of the filter
1 Contact surface
3 Gasket
insert.
Oil pump housing
2
4 Oil filter
Effectivity: 915 i A Series
Rev. 1